3D Resin printing

General Discussion
1

HI all,

I’ve been designing a few hard to get parts (typically small nylon clips and bushes) with the intention of getting them 3D Resin printed. I was not happy with the quality from the first company I used.

I notice a few contributions on the forum referring to 3D printing and wondered if any of you have any recommendations for companies that produce good results?

Paul

2

How about some different options for vented 1st gen strut bubbles on the hood?

1 Like
3

That is a bad idea because that allows water to run straight down onto the strut towers and water can be stagnent there and corrode those parts attatched to the strut tower.

4

Build it with a drip pan and a tube for water runoff like we have for the rear hatch.